Thanks for stopping by, and as always feel free to ask any questions. The power supply and board have worked perfectly fine and have been stored with care since last use.ĭue to the age of the unit I can’t guarantee much. Price of shipping to be determined.Īgain just to clarify the only issues that we’ve found are relating to the meter bridge, and really only cosmetic and do not alter the functionality whatsoever. Send message and we’ll work it out to make sure it’s packing and shipped as securely as possible. The unit has been set aside in our storage property covered but has been out of use so further repair isn’t much of a priority.ĭue to the weight and difficulty moving this unit around, local pickup is preferred, although shipping is an option. Also the meter bridge lost some screws during our recent move, which is why the arms are taped to the main body of the meter bridge currently. Unfortunately the right meter bridge arm took a hit and cracked, but was repaired with a steel grade binder, almost unnoticeable thanks to the color matching perfectly, but still of note. Only issues we’ve had have been cosmetic. I replaced all regulators and no more lights but lost phantom power.48/24-Channel dual input 8-bus mixing console with 24 input “Mix-B” channelsįully functional, with power supply and meter bridge fully functional as well. In your opinion, do you think I just need to replace the lm350t voltage regulator for the -18v and that fix the problem? Found myself a great deal on eBay recently, got myself an MX8000, recently serviced, meter bridge, power supply included etc. I know the power supply connection to the board is good and can't find any other cause of the problem. Now, it's gotten to the point to where it does that with the meter bridge unplugged and can't even use the board.

When I first plugged it in and tested everything, all seemed to work fine, but then, every time I hooked up the meter bridge the -18vdc light would go out and all the signal/peak LEDs would come on. Hey, I just picked up one of these mixers for $50 on Craigslist. this will prevent them from getting fryed! Clip an aligator clip between the solder gun and the body of the new part on each leg as you connect it. Make sure that you don't over heat them or they will be cashed right away. Un-bolted the old ones in the exact same spot re-bolted the new ones with heat sink cream, and soldered thr new legs to the old ones. instead of trying to de-solder the old regulators, I cut them out leaving plenty of leg length. they are the only part that is bolted to the heat sink when open the top of the cabnet. I changed all them anyway, I am sure another would have failed too. The only one that was bad in my power supply was the one for the +18vdc output. They consist of the following.ģ-lm350t from national semiconductor. The City of Fawn Creek is located in the State of Kansas. The solution to power supply problem is simple.

Behringer mx8000 meter bridge